I have been CNCing for 12 years and I have bought many spoil board bits, the ones where you can not change the blades, well once they get dull you have to either toss it or send it to a sharping facility, boy does that cost more than the tool. The SPETool I bought you can change the blades, when they get dull you simple replace them, Its like you have a new spoil board bit. I am looking to getting more SPE Endmills
A very sold and accurate tool, doing exactly as advertised and expected. The SpeTool CA P01003 Router Table Plate Dust Hood Collector is of high quality and working well with minimum dust getting into the air.
The only drawback is a stiff price. You gat what you pay for!
Finally started a project where I could use the 24β panel clamps. They are a game changer. Will be ordering some 36β clamps in the near future!
They are great. Keeps wood aligned and very easy to clean glue off rails.
These are very handy for glue ups. Well made and will be put to good use.