Esta broca enrutadora de 3 alas viene con una broca afilada con punta de carburo junto con cuerpos de acero endurecido. No importa cuánto tiempo trabaje con esta herramienta, estará lista para brindarle la experiencia de aplanamiento perfecta.
¿Le preocupan los problemas de calefacción mientras trabaja durante mucho tiempo? ¡Por favor no lo hagas! El grosor del inserto de 2,2 mm evitará daños y proporcionará una larga vida útil.
Puede cortar dentro de 2 pulgadas de diámetro usando esta broca enrutadora de 3 alas. Puede cortar con mucha precisión y suavidad, y no deja rebabas en la superficie de madera. Desde tareas pequeñas hasta proyectos complejos, esta fresa cabe en todas partes.
Características clave:
La punta de carburo afilada puede cortar suavemente.
Bueno para usar en cualquier proyecto pequeño o industrial.
Funciona muy bien con cualquier tipo de superficie de madera.
Se puede utilizar con todas las fresadoras automáticas para aplanar losas.
El cuerpo es duradero y bueno para un uso prolongado.
Bought this bit to flatten slabs of chainsaw milled wood. I’ve used it on half a dozen so far and it’s performing excellent. They are 10 year air dried apple about 15” wide by about 4-5’ long with severe twist and bow.
Instead of making my own, I purchased this because of the lower price, adjustable height, low weight, quick set-up, and easy storage. It was delivered well packaged and directions (along with their video) made assembly fairly straightforward. To date I’ve only flattened one 8 foot slab. I took the time to make a base out of 2x4s and use sawhorses. The router plate didn’t fit my Bosch router so I had to drill holes. It did as advertised.
My disappointments are the slight flexing of the aluminum extrusions while routing, and the amount of sawdust build-up under the wheels. I’m hoping to improve on this. I did use compressed air often. Overall, it meets expectations for an entry-level sled.
Four stars
I had hand surgery right after I ordered the fly cutter so I haven't been able to use it just yet. But the balance and the way it was designed I think it will work good. Here in about 2 weeks I'll be able to try it and will add to this review.
The price and delivery were good. I used this bit on my small CNC to surface some ash slabs about 2' x 2' x 4" thick that were chainsaw cut. I was not cutting end grain. It worked very well at 18k, 0.10 deep with 24% stepover. After cutting 4 of these faces I could tell the cutter was probably dulling a little because there was more heat in the cut. I did clean the carbide cutter surfaces after each cut. I would purchase this bit again.