SpeToolW05003La broca enrutadora CNC viene con 4 alas y se puede cortar con un diámetro de 2-½ pulgadas. Aunque el tamaño del vástago es similar al anterior.W05002broca enrutadora, su diámetro de corte es mayor que eso.
Una superficie dura no significa sólo una superficie de madera. Su hoja de carburo cementado puede aplanar cualquier superficie de madera, incluidas maderas duras y blandas, MDF, madera contrachapada, laminados y muchas más.
Características clave:
Las hojas son adecuadas para superficies de madera.
Su vibración extremadamente baja aumenta la eficiencia de corte.
No deja marcas de quemaduras en la superficie.
Contiene dos flautas de corte y dos ranuradores de corte hacia arriba, que brindan un acabado más suave en la parte inferior del corte que las tradicionales fresas de dos cuchillas.
Las cuchillas son reemplazables y pueden usarse durante mucho tiempo.
Bought this bit to flatten slabs of chainsaw milled wood. I’ve used it on half a dozen so far and it’s performing excellent. They are 10 year air dried apple about 15” wide by about 4-5’ long with severe twist and bow.
Instead of making my own, I purchased this because of the lower price, adjustable height, low weight, quick set-up, and easy storage. It was delivered well packaged and directions (along with their video) made assembly fairly straightforward. To date I’ve only flattened one 8 foot slab. I took the time to make a base out of 2x4s and use sawhorses. The router plate didn’t fit my Bosch router so I had to drill holes. It did as advertised.
My disappointments are the slight flexing of the aluminum extrusions while routing, and the amount of sawdust build-up under the wheels. I’m hoping to improve on this. I did use compressed air often. Overall, it meets expectations for an entry-level sled.
Four stars
I had hand surgery right after I ordered the fly cutter so I haven't been able to use it just yet. But the balance and the way it was designed I think it will work good. Here in about 2 weeks I'll be able to try it and will add to this review.
The price and delivery were good. I used this bit on my small CNC to surface some ash slabs about 2' x 2' x 4" thick that were chainsaw cut. I was not cutting end grain. It worked very well at 18k, 0.10 deep with 24% stepover. After cutting 4 of these faces I could tell the cutter was probably dulling a little because there was more heat in the cut. I did clean the carbide cutter surfaces after each cut. I would purchase this bit again.