La carpintería es un arte.Puedes ser creativo con un simple trozo de madera y probablemente convertirlo en una de las cosas más bellas del mundo. ¡Pero el principal enemigo de la creatividad es la"falta de herramientas perfectas" !
Algunos expertos en carpintería siempre utilizan la mejor fresa para cepillar y diseñar sus lienzos, también conocidos como piezas de madera. Una buena fresa le ahorrará tiempo y energía y garantizará la mejor elaboración de madera.
En las últimas publicaciones, presentamos 3fresas cepilladorasSpeTool Flattenning, todas las cuales son excelentes y tienen un buen desempeño y reputación en el mercado.
Ahora SpeTool ha creado una nuevabroca fresadora aplanadoracon un diámetro de mango de 1/4" y un diámetro de corte de 1-1/4", y ha sido un éxito inmediato entre los usuarios.
Las dos cuchillas superiores se utilizan para limpiar la parte inferior y las dos cuchillas laterales se utilizan para mecanizar los lados o cavar ranuras.
Las lamas son adecuadas tanto para superficies de madera como de aluminio.
Diámetro de corte de 1-1/4", mejorando aún más la eficiencia.
Las cuchillas son reemplazables y pueden usarse durante mucho tiempo.
Bought this bit to flatten slabs of chainsaw milled wood. I’ve used it on half a dozen so far and it’s performing excellent. They are 10 year air dried apple about 15” wide by about 4-5’ long with severe twist and bow.
Instead of making my own, I purchased this because of the lower price, adjustable height, low weight, quick set-up, and easy storage. It was delivered well packaged and directions (along with their video) made assembly fairly straightforward. To date I’ve only flattened one 8 foot slab. I took the time to make a base out of 2x4s and use sawhorses. The router plate didn’t fit my Bosch router so I had to drill holes. It did as advertised.
My disappointments are the slight flexing of the aluminum extrusions while routing, and the amount of sawdust build-up under the wheels. I’m hoping to improve on this. I did use compressed air often. Overall, it meets expectations for an entry-level sled.
Four stars
I had hand surgery right after I ordered the fly cutter so I haven't been able to use it just yet. But the balance and the way it was designed I think it will work good. Here in about 2 weeks I'll be able to try it and will add to this review.
The price and delivery were good. I used this bit on my small CNC to surface some ash slabs about 2' x 2' x 4" thick that were chainsaw cut. I was not cutting end grain. It worked very well at 18k, 0.10 deep with 24% stepover. After cutting 4 of these faces I could tell the cutter was probably dulling a little because there was more heat in the cut. I did clean the carbide cutter surfaces after each cut. I would purchase this bit again.