Decent product, if set up correctly... Unfortunately, the paper instructions are lacking alot of detail and are a bit confusing... I did need to procure longer plate screws to accommodate the DIY plate to match my router. And I also needed to get a 1/2" collet extension, since the rails add distance.
The sled must be built as square to your table, and square to itself as possible, for best outcome.
I recommend watching the assembly video, and using it to reference the paper instructions...
I highly recommend centering the bars to your perfectly level and flat surface. (I used sawhorses and a 4'x8'x1" sheet of plywood, attached to 2x4's, for my table) Then, using a framing square to perfectly align the roller brackets to the bars. That should be mentioned in the instructions.... Other than that, make sure to always have the rollers clean and their paths clear of debris. I used strips of wood to create a simple shroud for the wheels. I also am using forced air to keep the area around the wheels clear (on the closest side to the debris being created).
It should also be noted, to make sure the router plate is tight in place before cutting. I suggest locking the rear stop, then rotate the plate in place, then bring in the other stop tight to the plate. There should be no vibrations or noise.
And lastly, make sure your bits and fasteners are all tight, and to check them from time to time.
So far this sled is working well for what it's designed for.