The price and delivery were good. I used this bit on my small CNC to surface some ash slabs about 2' x 2' x 4" thick that were chainsaw cut. I was not cutting end grain. It worked very well at 18k, 0.10 deep with 24% stepover. After cutting 4 of these faces I could tell the cutter was probably dulling a little because there was more heat in the cut. I did clean the carbide cutter surfaces after each cut. I would purchase this bit again.
Fantastic bit. My carves are very detailed and so clean off the machine I have less than 5 min of cleanup sanding.
Worked great for my colorcore signs!
Worked great for my colorcore signs!
I think these bits are fantastic and highly affordable. I'd purchased more expensive bit from a different vendor, only to find that they became dull very quickly. I've purchased many sets of these for a fraction of the cost and am very happy that I did.