I had hand surgery right after I ordered the fly cutter so I haven't been able to use it just yet. But the balance and the way it was designed I think it will work good. Here in about 2 weeks I'll be able to try it and will add to this review.
The price and delivery were good. I used this bit on my small CNC to surface some ash slabs about 2' x 2' x 4" thick that were chainsaw cut. I was not cutting end grain. It worked very well at 18k, 0.10 deep with 24% stepover. After cutting 4 of these faces I could tell the cutter was probably dulling a little because there was more heat in the cut. I did clean the carbide cutter surfaces after each cut. I would purchase this bit again.
Fantastic bit. My carves are very detailed and so clean off the machine I have less than 5 min of cleanup sanding.
Worked great for my colorcore signs!
Worked great for my colorcore signs!